SETUP

Not connected

Browser not supported

Web Bluetooth requires Chrome on Android.
Safari, Firefox, and iOS are not supported.

Open this page in Chrome on Android, then use the menu to "Add to Home Screen" to install.

Connect to Device

Make sure Bluetooth is enabled and the device is powered and within range.

—
—
Authenticate
—
Battery
Idle
Sensor
Fw — raw —
Sensor Settings
Identity
Security
Detection
Detection LED
Flash LED on detection event
Battery Calibration (raw ADC)
LoRa Radio
Status
Ready
Mark setup complete (READY = 73)
Debug log

LoRa Test Communication

Sends a unique ID to the sensor via BLE. The sensor transmits it via LoRa to the paired terminal, which echoes it back. Verifies full LoRa round-trip without internet.

TCUID Sent Elapsed Reply
No tests run yet. Enter the terminal name and press Send Test.

Pair with Terminal

—
—

Scan the QR code or tap the NFC tag on the terminal to pair LoRa settings. The terminal name and LoRa frequency/SF/CR/BW will be copied to the sensor.

Point the camera at the QR code printed on or displayed by the terminal.

Hold your phone against the NFC tag on the terminal device.
Make sure NFC is enabled in Android settings.

Ready to scan